USA MAT-30 HF-SSB Automatic Antenna Tuner 120W Auto Tuner Ham Radio For Yaesu

• Popularity - 1233 views, 176.1 views per day, 7 days on eBay. Super high amount of views. 99 sold.
• Price - Avg: $0.00, Low: $0.00, High: $0.00. Best quality when compared to PicClick similar items.
• Seller - + items sold. 0% negative feedback. Great seller with very good positive feedback and over 50 ratings.

Description<br>mAT-30 HF-SSB Automatic Antenna Tuner 120W Auto Tuner Automatic Ham Radio for Yaesu<br>Operation English manual V1.2<br>Product Description:<br>- The mAT-30 is an automatic tuner intended for use with modern Yaesu transceivers.It works with some Yaesu transceiver that supports an FC-30,FC-40 or FC-50 Yaesu tuner;a partial list of compatible units includes:FT-100,FT-857,FT-897,FT-450D,FT-891.<br>The interface cable is included.<br>The operating is the same as the method of the Yaesu tuner, which is simple and convenient.<br>The mAT-30 can work within the range of 3MHz to 54MHz.<br>- The mAT-30 connects to the radio via its CAT/LINEAR jack to control the tuning cycle;the transceivers Tune button controls the tuner.The CAT/LINEAR jack also powers the tuner,so it requires no external power supply.The mAT-30 is specially engineered to integrate with your Yaesu FT-100/857/897/450D/891 HF radio.Tuning is performed when the TUNE button is pushed<br>on the front of the transceiver and held for one second.<br>- The mAT-30 provides automatic antenna tuning across the entire<br>HF spectrum plus 6 meters,at power levels up to 120 watts<br>.It will tune dipoles,verticals,Yagis,or virtually any coax-fed antenna.It will match an amazing range  of antennas and impedance,far greater than some other tuners you may have considered,including the built-in tuners on many radios.<br>- The mAT-30 is specially engineered to integrate with your Yaesu FT-100/857/897/450D/891 HF radio.The mAT-30 connects to the<br>CAT<br>(Computer Automated Transceiver)<br>port<br>on the back of the radio.The CAT interface allows an external device such as a PC or the mAT-30 to control the FT-100/857/897/450D/891 by sending it serial commands.The mAT-30 takes advantage of this interface to simplify the tuning process --one button push is all that is needed in order to switch the radio to FM mode,reduce output power, transmit a carrier, measure the transmit frequency,and then restore the radio to its previous mode and power level!<br>- The mAT-30 also features advanced memory tuning,providing 16000 memory locations;when tuning near a previously used frequency it will recall the settings for nearly instant tuning.It learns your favorite frequencies and bands as you use it.You can also start a tuning cycle manually whenever necessary.<br>- The mAT-30 has16,000 frequency memories.When tuning on or near a previously tuned frequency,the mAT-30 uses "Memory Tune" to recall the previous tuning parameters in a fraction of a second.If no memorized settings are available,the tuner runs a full tuning cycle, storing the parameters for memory recall on subsequent tuning cycles on that frequency. In this manner, the mAT-30 "learns" as it is the bands and frequencies as it goes.<br>Specifications:<br>- 0.1 to 120watts SSB and CW peak power,30 watts on PSK and digital modes,and 100 watts on 6 meters.<br>- Latching relays for ultra<br>- Low power operation.<br>- 16,000 memories for instantaneous frequency and band changing.<br>- Controlled from YaesuTUNE button on radio.Powered from Yaesu radio.<br>- Works with most Yaesu radios that are FC-30,FC-40 or FC-50 compatible.<br>- Partial radio list: FT-100,FT-857,FT-897,FT-450D,FT-891.<br>- Tuning time:0.1 to 5 seconds full tune,0.1 seconds memory tune.<br>- 1.8 to 54.0 MHz coverage. Built-in frequency sensor.<br>- Tunes 5 to 1500 ohm loads.<br>- For dipoles,verticals,Vees,beams,long wire or any coax-fed antenna.<br>- Includes interface cable.<br>- Dimensions:20x13x4cm (LxWxH).<br>- Weight:0.8Kg<br>AN IMPORTANT WORD ABOUT POWER LEVELS:<br>- The mAT-30 is rated at 125 watts maximum power input at most. Many ham transmitters and transceivers, and virtually all amplifiers, output well over 125 watts. Power levels that<br>significantly exceed specifications will definitely damage or destroy your mAT-30.<br>- If your tuner fails during overload, it could also damage your transmitter or transceiver. Be sure to observe the specified power limitations<br>Package List:<br>- 1 x mAT-30 HF-SSB Automatic Antenna Tuner<br>- 1 x Connecting cable<br>Special Explanation:<br>After actual comparison test，mat-30 is the only tuner that can tune the antenna with SWR higher than 3 when FT-891 is matched，even the Yaesu brand tuner can't do it.<br>Payment Terms<br>1.W